Silicone acetate, crystal clear

Name: Silicone acetate, crystal clear
Brand: Würth
SKU: 0892215

Silicone acetate, crystal clear
SILSEAL-ACE-GLASSCLEAR-310ML

Art.-no. 0892215

EAN 4024835288088

All versions

Specification

Crystal-clear sealant for joints in glass, display window and display case construction

Highly transparent

Permanently elastic

Notice

Not suitable for applications involving contact with food or for applications in structural glazing, on granite and natural stone

A glass seam seal is not recommended

Risk of corrosion when used on bare iron and coloured materials

Must not be applied to materials that may give off substances or by-products over time e.g. insulating and tar-based paints, butyl sealants or EPDM rubbers. Otherwise this may result in discolouration of the sealant or impaired adhesion.

Due to the large number of varnish and glazing formulations, always carry out your own tests on the area first, especially on alkyd resin paints and powder-coated aluminium

Yellowing on contact with white alkyd resin paints cannot be excluded

Use of a smoothing agent may cause the silicone to become cloudy

Not to be used in conjunction with pre-compressed sealing tapes

The usage instructions are recommendations based on the tests we have conducted and our experience; carry out your own tests before each application. Due to the wide range of applications and of storage and usage conditions, we cannot guarantee a specific application result. Insofar as our free customer service provides technical information or acts as an advisory service, no liability is assumed in relation to the provision of this service except where the advice or information given falls within the scope of our specified, contractually agreed service or the advisor was acting deliberately. We guarantee the consistent quality of our products. We reserve the right to make technical changes and further develop products.

Application

Application area

For sealing in glass, display window, window, display case and furniture construction

For small-sized bonding, for artistic applications, such as for glass ornaments or glass bricks

Instructions

The surface must be load-bearing, clean, dry and free from grease, rust and water

Do not use in heavy rain

The joint dimensions must be observed

Prime the joints with PE back-fill material

Rework dry before the skin forms as the use of smoothing agent can cause the silicone to become cloudy

Please observe the "General Notes on Application for Sealants" overview sheet. Further information in the technical data sheet.

Technical information

Container	Cartridge
Contents	310 ml
Chemical basis	Sauer silicones (acetate systems)
Colour	Crystal clear
Continuous motion absorption	12.5 %
Shore A hardness	20
Min./max. processing temperature	5 to 40 °C
Min./max. temperature resistance	-40 to 150 °C
Full curing speed/conditions	3 mm/d / 23°C and 50% relative humidity
Min. skin-formation time	15 min
Conditions for skin-formation time	at 23°C and 50% relative humidity
Min./max. full curing speed /conditions	2-3 mm/d / 23°C and 50% relative humidity
Min. breaking elongation	150 %
Fungicidal properties	No
Building material class	B2 - Normally inflammable
Shelf life from production	24 Month
Building material class/conditions	B2 - Normally inflammable / in accordance with DIN 4102
Density/conditions	1 g/cm³ / at 20°C
Density	1 g/cm³